MIG/MAG Short-arc
Carbon Steel S235JR, 4.5 mm, 200A (Recording B)
MIG/MAGShort-arcCarbon steel S235JR
Butt
Recorded with Rocket Retina · Standard enclosures · LED illumination on
Full HD 1080p
Welding Parameters
Process
Welding process
GMAW (MIG/MAG)
Transfer mode
Short-arc
Base Metal
Material
Carbon steel S235JR
Thickness
4.5 mm
Joint type
Butt
Position
PA (flat)
Preparation
Square edge
Electrical
Current
200 A
Voltage
22.0 V
Wire feed speed
9.5 m/min
Welding Source
Source
Stel S400 + F40
Camera
Enclosure
Standard
Illumination
LED, On
Technical Notes
- → Second recording at 200A on 4.5 mm carbon steel — identical WPS parameters as Recording A, different weld run for repeatability comparison
- → Slight natural variations in arc behavior and pool dynamics are visible when comparing frame-by-frame with Recording A
- → Both recordings confirm stable, consistent imaging — the camera does not require re-tuning between runs at the same parameters
Why this recording matters
Process repeatability is a key requirement for ISO 3834 and EN 1090 compliance. Two recordings at identical parameters demonstrate that both the welding process and the camera system produce consistent results across separate weld runs.
Want to see your specific process? We record new combinations regularly.